Manually Setting Time And Date - Conrad S3318P Mode D'emploi

d) Manually Setting Time and Date

When changing the year, month, date, hours or minutes, DCF reception is deactivated
automatically and the radio tower icon (H) goes out.
If this happens by accident, just perform a new DCF reception attempt after terminating
setting mode; see chapter 11. a).
When setting the 12h/24h mode and time zone, DCF reception is not deactivated.
• Push the „MODE" button (1) until the year starts flashing at the lower left of the display.
• Set the year with the buttons „UP/ALARM" (2) and „DOWN/DCF" (3)

Keep the respective button pressed for quick adjustment.
• Briefly push the „MODE" button (1); the month flashes.
Set the month with the buttons „UP/ALARM" (2) and „DOWN/DCF" (3).
• Briefly push the „MODE" button (1); the date flashes.
Set the date with the buttons „UP/ALARM" (2) and „DOWN/DCF" (3).
• Briefly push the button „MODE" (1); the hours of the time flash.
Set the hours with the buttons „UP/ALARM" (2) and „DOWN/DCF" (3).
• Briefly push the button „MODE" (1); the minutes of the time flash.
Set the minutes with the buttons „UP/ALARM" (2) and „DOWN/DCF" (3).
• Briefly push the „MODE" button (1); „12 Hr" or „24 Hr" flashes on the display.
Now use the buttons „UP/ALARM" (2) or „DOWN/DCF" (3) to switch between 12h and 24 h
mode.

In 12h mode, „PM" is displayed to the left of the time in the second half of the day.
• Briefly push the „MODE" button (1); then the time zone setting flashes.
• Now use the buttons „UP/ALARM" (2) or „DOWN/DCF" (3) to adjust the time zone in the area
of +12 to -12 hours.

After setting the time zone (another value than „0"), the time can be switched later by
a short push of the button „ZONE" (12) at the rear.
• Pressing „MODE" (1) again terminates setting mode.
49