Kenwood NX-5700 Mode D'emploi page 8

2
Press the [J] and [K] keys to select a unit ID from the list that has been pre-
entered into your transceiver.
The target unit ID/ name appears on the display.
●
Alternatively, you can enter a unit ID manually.
Press the [
●
the code. On an optional microphone with keypad, you can enter the code directly.
Press the [ ] key to confirm the code after entering the code.
To delete the code entered, press the [
the [ ] key to delete all digits.
3
Press and hold the PTT switch to make the call.
Speak into the transceiver as you would during a normal call.
●
The display will alternate between the called unit ID/ name and "Calling".
●
The LCD display will return to the zone and channel screen after call ends.
●
4
To end the call, press the key programmed as [Clear].
Making Group Calls (NXDN Conventional)
o
You can select a group ID from the list to make a call to those parties on a
Conventional channel.
1
Press the key programmed as [Group], [Group + Short Message] or [Group
+ Status] to enter Group Call Mode.
Alternatively, press the key programmed as [Menu] to enter Group Call Mode using the
Menu Mode.
The group ID list appears on the display.
●
8
] key to enter the manual input mode. Press the [J] and [K] keys to enter
] key to delete one digit, or press and hold