Basic Operations; Switching Power On/ Off; Adjusting The Volume; Transceiver Password - Kenwood NX-5700 Mode D'emploi

SWITCHING POWER ON/ OFF

Press [ ] to switch the transceiver ON.
The following screen appears if the Custom Start-up Screen has not been set.
●
Press [ ] again to switch the transceiver OFF.

ADJUSTING THE VOLUME

Press the key programmed as [Volume Up] to increase the volume. Press the key
programmed as [Volume Down] to decrease the volume.

TRANSCEIVER PASSWORD

If the transceiver is protected, "Input Password" will appear on the display when the
power is turned on. To unlock the transceiver, enter the correct password.
1
Press the key programmed as [Transceiver Password] to enter Transceiver
Password Mode.
Alternatively, press the key programmed as [Menu] to enter Transceiver Password Mode
using the Menu Mode.
If a password has been registered and the [Transceiver Password] function has not
●
been programmed to a key or configured to the menu, the transceiver enters
Transceiver Password Mode when the power is turned on.

BASIC OPERATIONS

3