Kenwood NX-5700 Mode D'emploi page 10

Alternatively, you can enter a unit ID manually.
Press the [
●
the code. On an optional microphone with keypad, you can enter the code directly.
Press the [ ] key to confirm the code after entering the code.
To delete the code entered, press the [
the [ ] key to delete all digits.
3
Press and hold the PTT switch to make the call.
Speak into the transceiver as you would during a normal call.
●
The LCD display will return to the zone and channel screen after call ends.
●
Making Group Calls (NXDN Trunking)
o
You can select a channel with the Group ID you wanted to call to make a call to those
parties on a Trunking channel.
If the traffic channel is busy, a busy message appears and the busy tone sounds. Release
●
the PTT switch and wait for the channel to become free. When the traffic channel becomes
free, a proceed tone sounds.
1
Select the configured Group channel using the keys programmed as [Channel
Up]/ [Channel Down].
10
] key to enter the manual input mode. Press the [J] and [K] keys to enter
] key to delete one digit, or press and hold