Scan Revert - Kenwood NX-5700 Mode D'emploi

SCAN REVERT

The Scan Revert channel is the channel selected when you press the PTT switch to
transmit during scan. Your dealer can program one of the following Scan Revert
channels:
Selected: The last channel selected is assigned as the new revert channel.
●
Selected + Talkback: If the channel has been changed, the newly selected channel is
●
assigned as the new revert channel. The transceiver "talks back" on the current channel.
Priority 1/ Priority 2: If your dealer has programmed a Priority channel (either Priority 1 or
●
Priority 2), this channel is the revert zone and channel.
Priority 1 + Talkback/ Priority 2 + Talkback: If your dealer has programmed a Priority
●
channel (either Priority 1 or Priority 2), this channel is the revert zone and channel. The
transceiver "talks back" on the current receive channel.
Last Called + Selected: The last channel on which you received a call is assigned as the
●
new revert channel. The transceiver "talks back" on the current channel. If the channel has
been changed, the newly selected channel is assigned as the new revert channel.
SCAN PROGRAMMING
Note:
Scan programming is only available when Scan Type has been set to "List".
●
Scan List Editing
o
You can reprogram your scan list to add or delete any channels.
1
Select the channel where the scan list to be edited has been set, press the key
programmed as [Scan Program] to enter Scan Program Mode.
Alternatively, press the key programmed as [Menu] to enter Scan Program Mode using
the Menu Mode.
2
Press the [H] and [I] keys to select the zone or the [J] and [K] keys to select the
channel you will add to or remove from the scan list.
3
Press the [ ] key to confirm your selection.
The indicator appears on the display when a channel is added to the scan list, and
●
disappears when a channel is removed from the scan list.
4
Press the [
Note:
A zone/ channel cannot be added to the scan list in the following cases.
●
When it has already been added to the scan list.
–
When a channel that is not compatible with the Scan Type in the Scan List setting has
–
been selected. (E.g., a P25 Trunking channel is selected when Scan Type in the Scan
List setting has been set to "Conventional".)
A zone/ channel cannot be deleted from the scan list in the following cases.
●
When the channel to be deleted is a Priority channel.
–
When there is no added channel in the scan list.
–
30
] key to exit scan programming.