Lcd Brightness - Kenwood NX-5700 Mode D'emploi

Key Delete <KeyDel>
o
Allows you to delete the Encryption key. Refer to "DELETING THE ENCRYPTION
KEY (AES/ DES (SCM) only)" {p. 36} .
Key Lock <KeyLck>
o
Press this key to lock the transceiver keys. Press the key again to unlock the keys.
The PTT switch and Power switch still function normally, and the following functions
can still be operated: Auxiliary Input, Call Response, Clear, Emergency, Function,
Hook, Key Lock, LCD Brightness, Monitor, Monitor Momentary, Squelch Off, Squelch
Off Momentary and Zeroize.
Keyset <Keyset>
o
Allows you to change the active Keyset stored in a Secure Cryptographic Module
(SCM).
LCD Brightness <Bright>
o
Allows you to adjust the brightness of the LCD backlight depending on the
surrounding lighting conditions.
Lone Worker <LoneWk>
o
Enables or disables Lone Worker function.
Low Transmit Power <Low>
o
Turns Low Transmit Power on or off. When using a channel programmed with
medium or high power, this allows you to change the output power to low.
Maintenance <Maint>
o
Allows you to display the signal strength and site information on the LCD when
constructing the system or during maintenance.
Medium Transmit Power
o
Turns Medium Transmit Power on or off. When using a channel programmed with
low or high power, this allows you to change the output power to medium.
Menu <Menu>
o
Press this key to select and perform functions using the transceiver Menu.
Mic Sense
o
Allows you to change the microphone sensitivity.
Microphone Type
o
Allows you to select a microphone type that suits the optional external microphone
connected.
Monitor <Moni>
o
Allows you to turn the transceiver signaling off, to listen to all calls that are received
on the channel.
24