General Safety Regulations And Protective Measures - ASO Safety Solutions SK 32-24 Manuel D'utilisation

SK 32-24 Safet�� Rela�� 32-24 Safet�� Rela�� Safet�� Rela��
2. General safet�� regulations and protective measures
• The manufacturer and users of the plant / machine on which the installation is being used are responsible
for implementing and following all applicable safety regulations and rules.
• The protection guarantees a level of functional safety on its own, but does not ensure the safety of
the entire plant / machine. The safety of the entire plant / machine must, therefore, be assessed in
accordance with machinery directive 2006/42/EC or appropriate product norm before using the device.
• The operating instructions must always be available at the place of installation of the protection.
They must be read thoroughly and observed by all persons involved in the operation, maintenance and
servicing of the protection.
• The protection must only be installed and commissioned by professionals familiar with these operating
instructions and the applicable operational safety and accident prevention regulations.
All of the instructions provided in these operating instructions must be observed and followed.
All electrical work must only be performed by skilled electricians.
• All relevant electrical engineering and Employer's Liability Insurance Association safety regulations must
be observed.
• During work on the switching unit, it is to be switched to zero potential, checked to ensure that it is at
zero potential and protected against being restarted.
• If the potential-free contacts of the relay output are supplied externally with a dangerous voltage, make
certain that these outputs are also switched off during work on the switching unit.
• The switching unit does not contain any components that require servicing by the user.
Unauthorised conversions and repairs made to the switching unit will void all guarantees and the
manufacturer's liability.
• The protection system is to be professionally inspected at appropriate intervals and be documented in
such a way that it is comprehensible at all times.
Safet�� advice
• Do not install in the immediate vicinity of strong sources of heat.
• For capacitive and inductive loads, ensure adequate protective circuits.
• It is not permissible to operate the safety relay while the housing is open.
The manufacturer assumes no liabilit�� in the event of non-observance or intentional
abuse.
12
Rela��