Engine Oil Change - Westinghouse WGen20000 Manuel De L'utilisateur

Générateur d'onduleur numérique, puissance d'opération 20,000 watts, puissance de pointe 28,000 watts
Masquer les pouces Voir aussi pour WGen20000:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE
Recommended Engine Oil Type
5W-30
°F
-20
0
20
°C
-28.9
-17.8
-6.7
Ambient temperature
Check the engine oil level before each use or every 8
hours of operation.
1. Place the generator on a level surface and allow the
engine to cool for several minutes.
2. Remove the oil dipstick and wipe the dipstick clean.
3. Insert, the remove the oil dipstick.
Acceptable Oil Level – On the flat side of the dipstick, oil
is visible up to the first notch.
Low Oil – Oil is below the first notch on the dipstick
4. If low, remove the oil fill cap and add the recommended
engine oil incrementally and recheck until the level is at
the top notch on the dipstick. DO NOT overfill. If over
the top notch on the dipstick, drain the oil to reduce the
oil level to the full mark.
5. Replace the oil dipstick and oil fill cap.

ENGINE OIL CHANGE

When using the generator in dusty conditions or extremely
hot weather, change the oil more frequently. Change the
oil while the engine is still warm from operation.
1. Place the generator on a level surface and allow the
engine to cool for several minutes.
2. With a damp rag, clean around the oil fill cap. Remove
the oil fill cap.
20 | Westinghouse Outdoor Power Equipment, LLC
10W-30
10W-40
5W-30 Synthetic
40
60
80
100
4.4
15.6
26.7
37.8
Acceptable oil level
3. Place an oil pan (or suitable container) under the oil
drain hose.
120
48.9
4. Remove the oil drain hose from the retaining clip. Open
the hose valve and allow the oil the to drain into the oil
pan.
5. Close the oil drain hose valve and secure the hose in
the retaining clip.
6. Place the oil pan under the oil filter. Remove the oil filter
by rotating it counterclockwise. Allow the oil to drain
completely. Clean the area where the oil filter contacts
the engine.
7. Apply clean oil to the rubber seal on the new oil
filter. Install by hand, turning clockwise until the seal
contacts the engine then turn another 3/4 turn. DO NOT
overtighten.
8. Fill with the recommended oil. Stop frequently to check
the oil level. DO NOT overfill. If the engine is overfilled,
the excess oil may get transferred to the air cleaner
housing and air filter. An indication of overfilling is white
or blue smoke coming from the muffler when the engine
is running.
Maximum oil capacity: 1.7 Quart (1.6 Liter)
9. Install the oil dipstick. Screw in the oil fill cap securely.
DO NOT pollute. Follow the guidelines of the EPA or other
governmental agencies for proper disposal of hazardous
materials. Consult local authorities or reclamation facility.
NOTICE

Publicité

Table des Matières
loading

Table des Matières