Data Center; Maintenance Reminders - Westinghouse WGen20000 Manuel De L'utilisateur

COMPONENTS

DATA CENTER

Use the Mode button on the Data Center to switch between
displays.
DATA CENTER
Voltage:
Displays current voltage
output.

MAINTENANCE REMINDERS

Maintenance reminder codes will be shown on the Data
Display based on unit lifetime hours. The maintenance
codes will be displayed until the unit is turned off. Refer to
the Maintenance section for specific procedures.
Maintenance Code Required Maintenance
P25
P50
P100
10 | Westinghouse Outdoor Power Equipment, LLC
Frequency (Hz):
Displays power output
frequency in Hertz.
Push the Mode button to cycle through
the data display modes.
Mode Button
Change engine oil
Change engine oil, clean air filter
Change engine oil, clean air filter,
replace fuel filter
Lifetime Hours:
Displays the lifetime run
hours.
Run Time/Maintenance:
Displays current run time.
Resets to zero when shut
down. Maintenance
reminder displayed
when required.