NORAUTO 2223453 Mode D'emploi page 46

2. Connect POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post battery. Connect NEGTIVE (BLACK) charger clip to
NEGTIVE (BLACK, N, -) post battery. Rock clip back and forth to make good connection.
WARNING: Do not face battery when making final connection.
1. Plug charger AC cord into a 220 volt main supply.
2. Switch on charger and then select amperage (See Controls Section).
WARNING: Be sure area around battery is well ventilated while battery is being charged. Gas can be forcefully blown away by
using a piece of card board or other non-metallic material as a fan.
1. Continue charging battery until the ammeter is close to Zero.
2. When battery is fully charged, unplug charger from AC power source frrst. then. (1) remove clip from Negative post, and (2)
remove clip from Positive battery post.
3. Clean and store battery charger.
SPECIFICATIONS
NOTE: When charging with MAX mode, please note user should keep monitoring the charger. In MAX Mode, it is a fast charging
mode and the charger should keep working for less than 1hour. Charging current selection:
POSITION
CHARGE+2+MAX+24V terminal
CHARGE+ 1+MAX+24V terminal
CHARGE+2+MIN+24V terminal
CHARGE+1+MIN+24V terminal
CHARGE+2+MAX+12V terminal
CHARGE+ 1+MAX+12V terminal
CHARGE+2+MIN+l2V terminal
CHARGE+1+MIN+12V terminal
STARTER (Engine-cranking)
Ingress Protection(IP)
FUSE
Recommend battery capacity
OUTPUT
24Vdc 35 A
24Vdc 29 A
24Vdc 22 A
24Vdc 16 A
12Vdc 33 A
12Vdc 28 A
12Vdc 21 A
12Vdc 15 A
7.5V 170 A(12V start)
15V 180 A (24V start)
3s on/120S off, 5 cycles maximum
20
1 X 80A
MAX. 600
MIN. 40
45
AH
AH