Description; Use Of The Product As Directed; Items Supplied - Hilti PX 10 Mode D'emploi

Symbols
Read the Return waste
operating material for
instructions recycling.
before use.
Type identification plate on the PX 10T
Made in Germany
Hilti = registered trademark of Hilti Corporation, Schaan, LI
Power:
Serial No.:
Manufact.:
This device complies with Part 15 of
the FCC Rules. Operation is subject
Item No.:
to the following two conditions: (1)
this device may not cause harmful interference, and, (2)
this device must accept any interference received,
including interference that may cause undesired operation.
Transmitter
Type identification plate on the PX 10R
Made in Germany
Hilti = registered trademark of Hilti Corporation, Schaan, LI
Power:
Serial No.:
Manufact.:
This device complies with Part 15 of
the FCC Rules. Operation is subject Item No.:
to the following two conditions: (1)
this device may not cause harmful interference, and, (2)
this device must accept any interference received,
including interference that may cause undesired operation.
Receiver

2 Description

2.1 Use of the product as directed

The Hilti PX 10 transpointer is a measuring system con-
sisting of the PX 10T transmitter and PX 10R receiver. It is
used to bring the receiver into alignment with the preset
position of the transmitter and to determine the distance
between the two units.
The system is capable of doing this through walls and
floors. The user can thus transfer reference points from
one side of a wall to the other and, at the same time,
measure its thickness. This makes it easier to determine
at which point the drill bit will come out on the other side of
a wall or floor when drilling a through-hole from a marked
hole-starting point. The system transfers positions from
one side of a wall or floor to the other and helps the user
to determine the required drill bit or core bit length. In
conjunction with the slope adapter, the transpointer can
be used to determine the exit point from a given reference
point and angle or, alternatively, the angle between two
given points.
Disposal of
batteries as
municipal
waste is not
permissible.
PX 10 T
9V nominal / 30mA
N4025
MIC
Z682
HLT-PX10
ДЕ01
IC: 5228A-PX1XR1
FCC ID:SDL-PX1XTR1
PX 10 R
9V nominal / 35mA
N4025
MIC
Z682
HLT-PX10
ДЕ01
IC: 5228A-PX1XR1
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the PX 10T transmitter.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Serial no.:
Location of identification data on the tool
The type designation and serial number can be found
on the type identification plate on the PX 10R receiver.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Serial no.:

2.2 Items supplied

1 PX 10T transmitter
1 PX 10R receiver
2 PDA 60 hand straps
2 9 volt batteries
1 PUA 91 adhesive putty
1 PUA 92 adhesive strips
1 Operating instructions
2 Manufacturer's certificates
1 Hilti toolbox
1 PXA 70 slope adapter
10 PUA 70 markers
en
11