IGNITION SYSTEM
INSPECTION STEPS
Use the following steps for checking the possibility of the malfunctioning engine being attributable to ignition system failure
and for checking the spark plug which will not spark.
Spark gap test
No spark
Check entire ignition system for connection.
(couplers, leads and ignition coil)
OK
Check engine stop switch.
OK
Check ignition coil. (primary coil and secondary
coil)
OK
Check CDI magneto. (pickup coil and charging
coil)
OK
Check neutral switch.
OK
Replace CDI unit.
*marked: Only when the ignition checker is used.
• Remove the following parts before inspection.
1. Seat
2. Fuel tank
• Use the following special tools in this inspection.
Dynamic spark tester:
YM-34487
Ignition checker:
90890-06754
Pocket tester:
YU-3112-C/90890-03112
↓
↓
↓
↓
↓
↓
→
Spark
*Clean or replace spark plug.
→
No good
Repair or replace.
→
No good
Replace.
→
No good
Replace.
→
No good
Replace.
→
No good
Repair or replace.
6-2
IGNITION SYSTEM