Maintenance - Conel FLOWSAN Instructions D'installation Et D'utilisation

42
Level sensor selection
CONEL level sensor kit FLOWNKS10
Three broken finger floats with plug-in couplings marked "A,B,C", stainless steel holder and fixing
material. Variable setting options. Long lower setting range for off / on and short upper setting range
for alarm.
For low inlets and little space in on-site pump sumps < 800 mm, with a minimum dimension of
460 mm between the lower edge of the inlet and the bottom of the sump.
Suitable for clear and dirty water without fibrous materials.
CONEL level sensor kit FLOWNSS10
Three float switches with plug couplings marked "A,B,C", stainless steel bracket, weights ,and fixing
material. Variable adjustment possibilities through three clamping segments for determining the
switching points Off / On / Alarm.
For higher inlets and sufficient space in on-site pump sumps > 800 mm, with a minimum dimension of
560 mm between the lower edge of the inlet and the bottom of the sump.
Suitable for wastewater with fibrous materials.
11.

Maintenance

ATTENTION!
Before carrying out any work, disconnect the control panel from the electrical system and secure it
from being accidentally switched on again. Check the discharge pipe line for damage.
To avoid danger if the power cable is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person.