Plug + Play - Conel FLOWSAN Instructions D'installation Et D'utilisation

9.1

PLUG + PLAY

The control panel is factory preset to FLOWTP12. When using FLOWTP30 OS it can be switched at
the pump preselector to the FLOWTP30 OS setting.
Further adjustments are not necessary due to the default values.
Manual operation
Automatic/Manual Switch pumps between automatic and manual
Auto
0
Buzzer off
Manual start of pump 1 or pump 2.
Pressing the Manual key for a short time will
automatically pump down to the switch-off point.
Pressing it again will stop the pumping process.
ATTENTION!
Prerequisite for manual operation is that the lowest
level transmitter "C" has risen - see functional
description of level control on page 33.
operation.
NOTE:
With "Manual" both indicator lamps for pump 1 and
pump 2 light yellow.
After five minutes without any further inputs, there
is automatic changeover from manual to automatic
operation.
Switch off buzzer, acknowledge fault message.
35