Interruption Of Work Till 4 Hours; Taking Out Of Operation And Cleaning - WAGNER W 100 Mode D'emploi

GB
•
Correct (Fig. 7a) Be sure to hold the spray gun at an even distance of approx. 5 - 15 cm
to the target object.
•
Incorrect (Fig. 7b) Heavy spray fog build-up, uneven surface quality.
•
Move the spray gun evenly cross-wise or up-and-down, depending on the spray pattern
setting.
•
An even movement of the spray gun results in an even surface quality.
•
When coating material builds up on the nozzle (A) and air cap (B) (Fig. 8), clean both
parts with a solvent or water.

12. Interruption of Work till 4 Hours

•
Turn the machine of.
•
When processing 2-component varnishes, clean the device immediately.

13. Taking Out of Operation and Cleaning

Proper cleaning is the prerequisite for problem-free operation of the paint application
device. No warranty claims are accepted in case of improper or no cleaning.
1) Unplug the power plug. Vent the container in case of longer breaks and after the work
has been terminated. This can be done by briely turning open and then closing the
container or by pulling the trigger guard and letting the paint into the original paint
container.
2) Divide the spray gun. Press the hook (Fig. 3 b "click") slightly downwards. Turn the gun
front part and gun rear part against each other and take them apart.
3) Unscrew the container. Empty any remaining coating material back into the material
tin.
4) Preclean the container and suction tube with a brush. Clean the ventilating bore
(Fig. 10, C).
5) Pour solvent or water into the container. Screw the container back on.
Do not use lammable materials for cleaning purposes.
6) Assemble the gun again (Fig. 3).
7) Insert the power plug, turn on the machine and spray the solvent or water into a
container or a cloth.
8) Repeat the above procedure until the solvent or water emerging from the nozzle is
clear.
9) Turn of the machine and remove the plug.
10) Screw of the container and empty it. Pull out the suction tube with container seal.
CAUTION!
Never clean seals, diaphragm and nozzle or air holes of the spray gun with metal
objects.
The ventilation hose and diaphragm are only solvent-resistant to a limited
extent. Do not immerse in solvent, only wipe.
11) Pull the ventilating hose (Fig. 10 A, 13) at the top from the gun body. Screw of the
22
W 100