Lighting The Pilot - Vulcan 2GR45MF Manuel D'installation Et De Fonctionnement

GRMF SERIES GAS FRYERS

Close the drain valve.

Fill the fryer tank with liquid shortening.

Shortening level should be between the min and max lines in the fryer tank.

Shortening will expand when heated. Do not fill the fryer tank past the
MAX line.

Add fresh shortening as needed to maintain oil level.
1. Open the door.
2. Turn the thermostat to OFF The thermostat is located behind the door.
3. Push the gas control valve knob and turn to OFF (see figure below, view A). Wait 5
minutes for unburned gas to vent.
4. Push and turn gas control valve knob to the "L" in PILOT (see figure below, view B).
5. While still holding the knob in, light the pilot with a lit flame. Continue to depress
the knob until pilot remains lit when knob is released. If the pilot does not remain lit,
repeat step 3 through 5.
6. Depress and turn gas control knob to ON (See figure below, view C).
7. If gas supply is interrupted, repeat steps 2 through 6.
VULCAN-HART

LIGHTING THE PILOT

A C
B
A – Gas Control Lever
B – Gas Valve
C – Thermostat
-11-
F-31233 Rev. T (12-15)