Functional Check Of The Compressor Without Edge Device - Prebena AEROTAINER 245 Manuel D'utilisation

WARILY
Damaged pressure lines can be broken, it lead to injury.
 Before connecting check the compressor and pressure lines on damages.
ATTENTION!
Damaged pressure lines can be broken and the stream of compressed air-out can inflict property
damage.
 Before connecting check the compressor and pressure lines on damages.

Functional check of the compressor without edge device

To ensure a faultless work of the compressor by first starting proceed as follows:
 Operate the compressor only in cool, dust-free, dry and well ventilated rooms.
 The ambient temperature should not be below 5 °C and above +40 °C.
 The slope of bearing surface in across-track and longitudinal directions should not be greater than 15
degrees to avoid damages of the compressor.
 Make sure that the minimum distance is complied between the compressor and any possible obstacle to
air flow is 50 cm.
 Before starting make sure that voltage and supply frequency correspond to data on the plate with char-
acteristics of the compressor.
ATTENTION!
Operation with power supply with out following above conditions can lead to compressor damage.
 Connect the compressor only to appropriate power supply.
ATTENTION!
 Pay attention to instructions about possible dangers in the chapter "Safety" beginning from page 5.
Description
17