Control Elements - Prebena AEROTAINER 245 Manuel D'utilisation

Description

Control elements:

VIGON 100, VIGON 240, VIGON 300, ORKAN 215,
PIONEER 282 and PIONEER 342
AEROTAINER 240
WARRIOR 255 and WARRIOR 435
 Connect the compressor to the power supply.
Extension cables should have a cross section minimum 2.5 mm2 and can have length maximum

30 m.
Turn the pressure reducer (2) by turning it counterclockwise.
 Switch on the compressor using the switch (1) to start it.
 Let the compressor run for approximately 10 minutes without load.
 In this case check the following points:
−
If pressure rises in the air receiver? You can see it on manometer (3)
−
If the compressor switches off automatically by achievement of maximum pressure? (see technical
specifications, starting from page 7)
Maximum allowable operating pressure produced by the compressor is limited automatically by the pressure
relay. Safety valve limits additionally the pressure rise above 10% of maximum allowable.
18
№ Explanation
1 Switch
2 Pressure reducer
3 Manometer for pressure measurement in the air receiver
4 Manometer for operating pressure measurement of edge
device
5 Union nipple for edge device (adjustable)
№ Explanation
1 Switch
2 Pressure reducer
3 Manometer for pressure measurement in the air receiver
4 Manometer for operating pressure measurement of edge
device
5 Union nipple for edge device (adjustable)
6 Union nipple for edge device (pressure in boiler)
№ Explanation
1 Switch
2 Pressure reducer
3 Manometer for pressure measurement in the air receiver
4 Manometer for operating pressure measurement of edge
device
5 Union nipple for edge device (adjustable)