Compressor Gathering; Checkup - Prebena AEROTAINER 245 Manuel D'utilisation

Description

Compressor gathering

Some components are supplied separately in package and they are not installed on the compressor.
VIGON 120:

oil-filling hole plug (2)

air filter (3)
VIGON 120:
 Fix air filter (3), screw it manually on the cylinder head.
 Remove transport plug of oil-filling hole.
 Set the plug (2) on the neck of oil tank by turning it.
VIGON 240:
 Put axes into holes on the smooth side of running wheels (1).
 Fix axes from the side of tail bearings (nut with the key 17).
 Fix air filter (3), screw it manually on the cylinder head.
 Remove transport plug of oil-filling hole.
 Set the plug (2) on the neck of oil tank by turning it.
VIGON 300:
 Put axes into holes on the smooth side of running wheels (1).
 Fix axes from the side of tail bearings (nut with the key 17).
 Fix air filter (3), screw it manually on the cylinder head.

Checkup

WARNING
Risk of accidents by using faulty compressor.
 Check condition of the compressor before each use.
 Make sure that the compressor is in perfect condition.
 In particular check the following:
−
If the safety valve is faultless?
−
If the air filter is set on the cylinder head?
−
If running wheels are set on types VIGON 240 and VGON 300?
−
If the oil level is enough?
−
If the connection to power supply is in order?

Scratches on the casing are not a failure.
 Do not connect faulty compressor to the power supply.
 Before starting the operation of the compressor refer to employees of company PREBENA so they carry
out the repair.
16
VIGON 240:

running wheels with axes
and screw nuts (1)

oil-filling hole plug (2)

air filter (3)
VIGON 300:

running wheels with ax-
es and screw nuts (1)

air filter (3)