Separating The Cartridge From The Device - Prebena KT-3500 Mode D'emploi Original

Using the Cartridge
 Unscrew the sealing cap from the valve.
 Check the valve for foreign objects and contamination.
 Clean the valve, if necessary (see page Fehler! Textmarke nicht
definiert.).
 Check the condition of the cartridge (see page 9).
 Slide the cartridge with the valve at the head into the brackets on
the device.
 Screw the cartridge hand-tight into the thread at the device
connection.

Separating the cartridge from the device

Conduct the following steps after the operation or after service
interruption:
 Unscrew the cartridge from the connection thread.
 Pull the cartridge back from the brackets on the device.
 Screw the sealing cap onto the cartridge's valve.
 Store the cartridge in the delivered transport case protected
against shock and blows.
10
WARNING
There is risk of explosion when exceeding the
maximum operating pressure (see operating
manual of the fastener driving tool).
 In this case, separate the cartridge from
the device immediately.
WARNING
Operation on unsuitable devices can cause
damage to the cartridge and the device.
 Connect the cartridge to devices approved
by the manufacturer only.