Alarm Options; Digital Radio (Dab/Dab+/Dmb) Mode; Station List; Advanced Mode - Tivoli Audio PAL+BT Manuel Utilisateur

IMPORTANT NOTES:
•
The alarm cannot sound if the PAL+BT is off and not connected to the external adapter.
•
The alarm volume will ramp-up over time. It will take several seconds until the alarm reaches the volume
level set in the alarm menu.
•
Should power be lost or the battery becomes discharged, the alarm time will be saved, but the alarm
cannot sound without power to the PAL+BT.

ALARM OPTIONS:

Alarm Quick Set: With the PAL+BT in standby, repeatedly press the alarm button briefly to toggle each alarm
on or off.
Alarm Off: To stop the alarm, press the Alarm or Power button on the remote.
Snooze: To activate Snooze, press the Snooze button on the remote. The Snooze time is not adjustable. When
operating on battery-only power, pressing Snooze will have no effect.
Note: When in Snooze mode, you can see the remaining Snooze time by pressing the Snooze button on the
remote. If you press the Alarm or Power button on the remote, then the Snooze countdown will be cancelled and
the PAL+BT will go into Standby or off if operating on battery-only power.

Digital Radio (DAB/DAB+/DMB) Mode

STATION LIST: Use the pq buttons on the remote to show all available DAB/DAB+/DMB stations. Use the
pq buttons to highlight a specific station and the Select button to tune that station. The Station list will disappear
after 7 seconds.
Press and hold the Menu button on the remote to enter the main menu. Use the pq buttons and the Select
button to change the items within the menu. Use the Back button to navigate back, or wait for 15 seconds until
the timeout expires.
An asterisk (*) indicates the shown menu item is currently set.
NOTE: Upon entering Digital radio mode, if the Station list is empty, a full scan will initiate.
FULL SCAN: Searches the entire frequency range. If you move the PAL+BT to another location, you must
1.
perform a new scan so the radio will find stations in the new location. To cancel the auto scan, press the Back
button on remote.
EQUALIZER: Please refer to the section marked "Menu and Specific Features".
2.
MANUAL TUNE: Press the pq buttons to manually tune specific DAB/DAB+/DMB frequencies, then press
3.
Select to tune the displayed frequency.
DRC: Dynamic Range Control allows you change the sound level of stations to make quiet passages louder
4.
to compensate for a noisy environment, or when listening at a low volume level.
ADVANCED MODE: If the PAL+BT is relocated to a different area, you may find stations with the same name.
5.
If you enable "Advanced View", "Long labels", and "Show Ensemble" under Advanced Mode, you will be able to
differentiate between extended station names.
For DAB/DAB+, we suggest disabling all the Advanced Mode settings. For DMB, we suggest enabling them.
PRUNE: If the PAL+BT is relocated to a different area, some stations may become unavailable. Select "Prune"
6.
to remove unavailable stations from the Station list. Use the pq or
confirm (Yes) or deny (No) removing unavailable stations.
NOTE: When moving the PAL+BT to another location where there may be different DAB stations from
the previous location, it is recommended to run a "Prune" to remove unavailable stations.
t u
buttons and the Select button to
11 – ENGLISH