Remote Control - Tivoli Audio PAL+BT Manuel Utilisateur

Remote Control

In addition to duplicating most of the front panel controls, the remote control adds the following functions:
POWER: Press briefly to power the PAL+BT on. The
1.
radio will power on to the last source used. Press again
to power off. The remote's Power button will not turn the
PAL+BT on when the unit is off and not connected to the
external power supply.
Mute/Snooze: Press to mute the audio (the
2.
show no volume bars) while the unit is playing and press
again to restore sound, or adjust the volume. Press to
mute the alarm after the alarm sounds. A
show on the display when Snooze is active. The Snooze
time is fixed at 7 minutes and is not adjustable. The
Snooze function works when the PAL+BT is connected
to the external power supply. When operating on battery-
only power, pressing Snooze will have no effect.
ALARM: Use the tu and Select buttons pq to adjust and
3.
set the alarms. For very important notes and a complete
step-by-step guide, refer to the section titled "How to
set the Alarm".
SLEEP: Press repeatedly to view the amount of time the
4.
radio will play before it turns off automatically and press
the Select button to select that time. When the sleep timer
is active you can check the remaining time by pressing
the Sleep button on the remote. A
display when the Sleep timer is active. To cancel Sleep,
press the Sleep button until the display shows "Off".
When operating on battery-only power (external adapter
not plugged-in), if Sleep is engaged and the alarm is set,
after Sleep ends, the alarm will not sound. To use both
Sleep and Alarm features, please be sure the external
adapter is connected.
SOURCE: Press repeatedly to change sources.
5.
INFO: Press repeatedly to cycle through the information available depending on the source mode. This func-
6.
tion does not work in Auxiliary mode.
PRESETS 1-5: Press and hold to store the currently tuned station. Press briefly to recall the station associ-
7.
ated with that specific preset. In FM mode, the preset number will be indicated on the display. There are 5
presets for each band.
VOLUME +/–: Press the Volume + button to raise the volume level or the Volume – button to lower the volume
8.
level. If the audio ever sounds distorted, lower the volume level to avoid damaging the speaker. Adjusting the
volume while the PAL+BT is muted will cancel the muting.
pq: Press to navigate within the menus. Use these same buttons to manually tune up or down when in FM
9.
mode and to Full Scan stations. A "T" will show on the display to indicate manual tuning mode. Press and hold
to move quickly through the frequencies. It will take a second until the frequencies begin to change. Press for
1.5 seconds and release to Full Scan to the next station detected. The display will show "Scanning..." Also
refer to "Scan Setting" under the section "Menu and Specific Features".
10. t u: The right arrow button duplicates the Select button. The left arrow button duplicates the "Back" button
in certain menu items.
11. MENU/SELECT: Press and hold to enter the main menu and press briefly to select items within the menu.
For more, see the section marked "Menu".
4
2
icon will
3
icon will
12
11
8
will show on the
5
1
6
7
9
13
10
14
8 – ENGLISH