Roborock S5 Max Mode D'emploi page 21

Installation
On/Off
Press and hold the button to turn on the robot. The
power indicator will turn on and the robot will enter Standby
mode. If the robot is in Sleep mode, press and hold the
button to turn it off and end the current cleanup.
Note:
The robot cannot be turned off when it is charging.
Start cleanup
Press the button to start cleaning. Once started, the
robot will plan its cleaning route based on its scan of the
area. It cleans along the edges of a zone first and then
moves in a Z-shaped cleaning route to cover the internal
area efficiently and thoroughly.
Zone 1: Clean
Zone 4: Pending
Zone 2: Clean
Zone 3: Cleaning
Note:
• Cleaning cannot start if the battery level is too low. Allow the robot to charge
before restarting cleanup.
• Tidy away any cables on the ground (including the power cable of the charging
dock) before cleaning to avoid losing power or damaging either the robot or
the connected device.
• If a cleanup finishes within 10 minutes, cleaning repeats by default
• If the battery runs low before cleanup is complete, the robot will carry out a
top-up charge before resuming cleanup from where it left off.
Pause
When the robot is cleaning, press any button to pause it.
Then press the button to continue cleaning or the
button to return it to the charging dock and stop the
cleaning cycle.
Note:
Placing a paused robot on the charging dock manually will end the current
cleanup.
Sleep
If the robot is paused for over 10-minutes, it will go to sleep,
and its power indicator will flash slowly. Press any button to
wake it back up.
Note:
• The robot will not go to sleep when it is on the charging dock.
• The robot will automatically shut down if left in sleep mode for more than 12 hours.
17