Roborock S5 Max Mode D'emploi page 19

Installation
Using the robot
6. Mopping
Note:
It is recommended that all floors are vacuumed at least three times before the
first mopping session to reduce excessive dirt buildup on the mop.
Remove the water tank
1
Press down the water tank latch and slide the tank
backwards to remove it.
Fill the water tank
2
Open the water tank, fill it with water, and close it tightly.
Note:
• To prevent corrosion or damage, do not use cleaning fluid or disinfectant
in the water tank.
• Do not use hot water, which may cause the tank to deform.
Install the water tank
3
Slide the water tank into the robot until you hear it lock
with a click.
Install the mop cloth
4
If mopping immediately, dampen the mop cloth and
squeeze it dry then attach it to the mop cloth bracket.
Note:
Use a barrier tape or no-mop zones to separate prevent mopping on
carpeted floors.
15