Spot Cleaning - Roborock S6 MaxV Mode D'emploi

Instructions for use
Charging
Auto: After cleaning, the robot will automatically return to the Charging
Dock to recharge.
Manual: In Pause mode, press the
the Charging Dock.
The power indicator will breathe as the robot charges.
Note:
If the robot cannot find the Charging Dock, it will return to the most recent starting location. Place the
robot on the Charging Dock manually to recharge.
Error
If an error occurs while the robot is cleaning, the power indicator flashes
red and a voice alert will sound. See Troubleshooting for solutions.
Note:
・
The robot will go to sleep automatically if left in an Error state for over 10 minutes.
・
Placing the robot on the Charging Dock in an error state will stop the current cleanup.
Reset WiFi
If the mobile phone fails to connect to the robot because the router
configuration has changed, the password has been forgotten, or for any
other reason, open the upper cover and find the WiFi indicator. Press and
hold the and buttons until you hear the "Resetting WiFi" voice
alert. Reset is completed when the WiFi indicator starts to flash slowly,
showing that the robot is waiting for a connection.
Note:
If the robot waits more than 1 hour for a connection, WiFi will be automatically disabled. If you need to
reconnect, reset the WiFi before proceeding.
button to send the robot back to

Spot Cleaning

When the robot is in standby or pause mode, press the
spot cleaning. In this mode, the robot cleans an 1.5m x 1.5m square area
centered on the robot. After spot cleaning, the robot will automatically
return to the starting point and stop cleaning.
Note:
Starting spot cleaning in Pause mode will stop the current cleaning cycle.
24
button to start
1.5m