PROUSER SAFFIER III Notice D'assemblage Et De Sécurité page 35

Step 4
Parts:
Mounting:
Loosen and remove the little screws intended for the mounting of the number
plate holder from the light holder rail and fasten the number plate holder to the
rail. The number plate holder has to be level (or just above) with the lighting.
Attention: The fastening clips to secure the number plate are incorporated in the
number plate holder and can be pressed out.
With the provided cable ties, the light cable can be fastened neatly at the bottom
of the carrier. Make sure the cable will not interfere with the tilting mechanism.
Slide the six short, black straps through the little slots in
the wheel holder, starting inside-out, going around the
wheel holder and then outside-in (see picture).
End result:
Unscrew the plastic rotary knob of each frame holder,
so the clamps can be folded open. First attach the
rubber ring around the U-frame and put the clamp
around it. Subsequently, re-attach the holder and
screw the plastic rotary knob until you can just turn
the frame holders (the frames of the bikes have to be
attached to it, so they have to be movable). The sides
with the straps are intended to fasten the bike.
35