Equipment; Technical Data - ESAB MobileFeed 301 AVS Manuel D'instructions

3 TECHNICAL DATA

50 to 750 in/min (1.3 - 19.0 m/min). The feeder components are totally enclosed in a rugged
case.
ESAB's accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
2.2

Equipment

The MobileFeed 301 AVS is supplied with:
• Instruction manual
• Voltage pickup cable with clamp
3 TECHNICAL DATA
NOTE!
The MobileFeed 301 AVS is not recommended for short circuiting transfer using
constant current power sources due to the limited short circuit current available
on constant current power sources.
Wire feed speed
Primary input (open circuit voltage or arc voltage) Not for use with AC power
Minimum
Welding
Maximum
Standard spindle hub
Standard spool
Maximum welding current
Maximum gas inlet pressure
Wire diameters
Hard
Soft
Cored
Motor type
Brake type (wire)
Control
Feed system
On-Off switch
Ramp start
0558 012 633
MobileFeed 301 AVS
50 – 750 in/min (1.3 – 19.0 m/min)
14 V DC
45 V DC (when welding)
100 V DC (113 V peak)
2" (50 mm) ID
8" (200 mm) OD, 12" (300 mm) OD
320 A at 60% duty cycle
250 A at 100% duty cycle
75 psi (5.2 Bar)
.030" (0.8 mm), .035" (0.9 mm),
.045" (1.2 mm), .052" (1.4 mm),
1/16" (1.6 mm)
.035" (0.9 mm), 3/64" (1.2 mm),
1/16" (1.6 mm)
.030" (0.8 mm), .035" (0.9 mm),
.045" (1.2 mm), .052" (1.4mm),
1/16" (1.6 mm), 5/64" (2.0 mm)
DC permanent magnet pre-lubricated, enclosed
Drag
Solid state
Push
Standard
Standard
- 10 - © ESAB AB 2015