Introduction; Equipment - ESAB WARRIOR 500i CC/CV Manuel D'instructions

US
This product is solely intended for arc welding. Any other use may result in personal
injury and / or equipment damage.
Class A equipment is not intended for use in residential locations
where the electrical power is provided by the public low-voltage
supply system. There may be potential difficulties in ensuring
electromagnetic compatibility of class A equipment in those
locations, due to conducted as well as radiated disturbances.
ESAB can provide you with all necessary welding protection and accessories.
2

INTRODUCTION

The Warrior 500i CC/CV is a welding power source intended for GMAW welding, as
well as for welding with powder filled cored wire (FCAW-S), GTAW welding, welding
with coated electrodes (SMAW) and arc air gouging.
The power source is intended for use with the following wire feed units:
S
Warrior Feed 304
S
Mobile Feed 300
ESAB's accessories for the product can be found on page 55.
2.1

Equipment

The power source is supplied with:
S
5 m return cable with clamp
S
instruction manual
bu22a
- 7 -
© ESAB AB 2013