Equipment Maintenance; Additional Safety Information - ESAB EMP 215ic Manuel D'instructions

1 SAFETY PRECAUTIONS
WARNING!
FALLING EQUIPMENT CAN INJURE
• Only use lifting eye to lift unit. Do NOT use running gear, gas cylinders or
any other accessories.
• Use equipment of adequate capacity to lift and support unit.
• If using lift forks to move unit, be sure forks are long enough to extend
beyond opposite side of unit.
• Keep cables and cords away from moving vehicles and moving
equipment when working from an aerial location.
WARNING!

EQUIPMENT MAINTENANCE

Faulty or improperly maintained equipment can cause injury or death.
Therefore:
1. Always have qualified personnel perform the installation, troubleshooting
and maintenance work. Do not perform any electrical work unless you
are qualified to perform such work.
2. Before performing any maintenance work inside a power source,
disconnect the power source from the incoming electrical power.
3. Maintain cables, earthing wire, connections, power cord and power
supply in safe working order. Do not operate any equipment in faulty
condition.
4. Do not abuse any equipment or accessories. Keep equipment away from
heat sources such as furnaces, wet conditions such as water puddles, oil
or grease, corrosive atmospheres and inclement weather.
5. Keep all safety devices and cabinet covers in position and in good repair.
6. Use equipment only for its intended purpose. Do not modify it in any
manner.
CAUTION!

ADDITIONAL SAFETY INFORMATION

For more information on safe practices for electric arc welding and cutting
equipment, ask your supplier for a copy of "Precautions and Safe Practices
for Arc Welding, Cutting and Gouging." Form 52-529.
The following publications are recommended to you:
1. ANSI/ASC Z49.1 - "Safety in Welding and Cutting"
2. AWS C5.5 - "Recommended Practices for Gas Tungsten Arc Welding"
3. AWS C5.6 - "Recommended Practices for Gas Metal Arc Welding"
4. AWS SP - "Safe Practices" - Reprint, Welding Handbook
5. ANSI/AWS F4.1 - "Recommended Safe Practices for Welding and
Cutting of Containers That Have Held Hazardous Substances"
6. OSHA 29 CFR 1910 - "Safety and Health Standards"
7. CSA W117.2 - "Code for Safety in Welding and Cutting"
8. NFPA Standard 51B, "Fire Prevention During Welding, Cutting, and
Other Hot Work"
9. CGA Standard P-1, "Precautions for Safe Handling of Compressed
Gases in Cylinders"
1 ANSI Z87.1, "Occupational and Educational Personal Eye and Face
0. Protection Devices"
0463 407 001 - 9 - © ESAB AB 2017