Supply Connections - ESAB MobileFeed 301 AVS Manuel D'instructions

4 INSTALLATION
WARNING!
Turn off the power to the welding power source and the wire feeder before
making any connections between the wire feeder and the welding power source.
The torch adapter on the MobileFeed connects directly to the wire feeder wire drive
assembly, power and shielding gas supply.
1. Line up the torch connector with the wire feeder adapter and push it on firmly.
2. Hand tighten the locking collar on the Euro connector.
4.8

Supply connections

CAUTION!
Turn off the power source and the wire feeder.
The MobileFeed 301 AVS can be used with either DC Electrode Positive (DCEP) or DC
Electrode Negative (DCEN) polarity without modifications.
0558 012 633 - 15 - © ESAB AB 2015