Controls And Functions - WAGNER PAINT CREW Mode D'emploi

Paint Crew
Components
•
Spray gun with filter
•
Spray tip assembly
•
7,5 mtr. long, 1/4 Zoll diameter high pressure hose.
Tools needed for assembly
•
Two adjustable wrenches.
WARNING
Do not plug in the unit until setup is complete.
Handle
Return
tube
Hopper
Frame
Outlet
valve
Tip
storage
Spray
gun
Assembly
1
Place the handle over the unit frame.
Insert the bolts and tighten the wing
nuts over the lock washers.
COMPONENTS AND ASSEMBLY
Hopper lid
Spray tip
assembly
Trigger lock
Trigger
Tip Tip
guard
2
Thread one end of the high pressure spray
hose to the outlet valve.
Tighten with an adjustable wrench.
Attach return tube to hopper.

Controls and functions

ON/OFF switch
Spray Gun
Spray Hose
Return Tube
PRIME/SPRAY knob
Inlet filter
(inside of hopper)
Motor
housing
Rear
handle
ON/OFF
switch
Inlet valve
tool
PRIME/SPRAY
knob
Spray
hose
The ON/OFF switch turns the unit
on and off (O = OFF, l = ON)
The spray gun controls the
delivery of the fluid being
pumped.
The spray hose connects the gun
to the pump.
Fluid is sent back out through the
return tube to the hopper when
priming.
The PRIME/SPRAY knob directs
fluid to the spray hose when set
to SPRAY, or the return tube when
set to PRIME.
ON/OFF Switch
PRIME/SPRAY
PRIME
position
SPRAY
SPRAY
position
3
Thread the other end of the hose to
the spray gun. Hold the gun with one
adjustable wrench, and tighten the
hose nut with the other.
GB
= ON
= OFF
knob
23