Migatronic PI 350 PLASMA Guide De L'utilisateur page 16

Special functions
Dynamic Oxide Control
0 = disabled
1 = enabled (default setting)
Remote Control Option
Welding current can be controlled up to previous
SET or to MAX. External reference voltage can
be 0-10V or 0-5V (Condition 2 & 3 presents lower
resolution)
0 = 0-10V
1 = 0-10V
2 = 0-5V
3 = 0-5V
Torch Remote Control
Applies to software versions as of 2.17
Makes it possible to control how the control unit on
the handle is used when torch adjustment is enabled
( ).
0 = Setting the current reference (factory default).
1 = Enabling/disabling TIG-A-Tack
(the TIG-A-Tack button is disabled).
The control unit is handled as
follows:
Steps 1-3: TIG-A-Tack is enabled
Steps 4-7: The trigger is disabled
Steps 8-10: TIG-A-Tack is disabled
2 = Up/Down module
2A/
Enabling/Disabling
*
Keep pressed for constant increase/reduction
Learn more about TIG Ergo torches at
Saves all program settings in an SD card file. Insert an SD card
in the machine (same procedure as for SW update).
Loads program settings from SD card.
Use P.SA. to save program settings.
All the above settings will not be changed during reset to factory
settings.
 Imin to ISET (default)
 Imin to IMAX
 Imin to ISET
 Imin to IMAX
Trigger Trigger
* * *
2A/ 2A/
TIG-A-Tack
http://migatronic.com
*
2A/
16