Other Function Settings; Minimum Value Display Settings; Key-Tone Clue On Function Settings; Display Monitor Brightness Settings - MW TOOLS BB200 Mode D'emploi

M1.2.BB200.NLFREN 13112018
EN

15 Other function settings

15.1 Minimum value display settings

After select minimum value display, even wheel imbalance value less than setting value, result will be display 0(zero),press FINE
key, will be display fact imbalance value.
Press STOP and D key, ect figure 15-1, denotation imbalance value less than 5 gram, display is 0g (zero gram).
Press b+ or b- key setting minimum value, are 5 and 10 and 15 gram three distinctions.
Press a+ key to save settings and enter next step.
Fig. 15-1

15.2 Key-tone clue on function settings

This function can turn on or turn off key-tone, even turn on this function, every time press key, system will be emit a "di" of
tone, even turn off this function, press key not tone. From 15.1 press a+ enter settings, ect figure 15-2,right side display ON
denotation function on, display OFF denotation function off.
Press b+ or b- key, function will be switch between "ON" and "OFF".
Press a+ key to save settings and enter next step.
Fig. 15-2

15.3 Display monitor brightness settings

This function will follow use environment and user need, setting display brightness.
From 15.2 press a+ enter settings, ect figure 15-3, right side display brightness grade, altogether is 8 levels, level 1 is darkest,
level 8 is brightest, default is level 4.
Press b+ or b- key, function will be switch brightness levels.
Press a+ key to save settings and enter next.
Fig. 15-3

16 Machine self test function

This function will check all kinds input signal whether right working and provide gist for trouble analyses.

16.1 LED and indicator light check

Press D key, whole LED and indicator light all turn on, this function can be check LED or indicator light whether appear
damage, press C key to exit, after about 5 seconds display ect figure 16-1,enter position sensor check.
Press C key to exit.
Fig. 16-1
51