Direct Imbalance Optimise; Gram-Oz Conversion Operation; Inch-Mm Conversion Operation; Protect Hood Function And Protect Setting - MW TOOLS BB200 Mode D'emploi

Slowly spin wheel by hand again, when both side one of middle position indicator light flashing(figure 11-4). Use mark pen
make a mark on the rim.
Remove the wheel from balancer, use tyre changer remove tyre from rim, make tyre and rim marks together, use tyre changer fit
tyre on the rim, optimise complete.

11.2 Direct imbalance optimise

Turn on the power, installation wheel, press OPT key, left side display OPT, press START key, display ect figure 11-1, then follow
11.1 step to operation. Press STOP key to stop operation.

12 Gram-Oz conversion operation

1. Press STOP key and a+ key or a-, display ect figure 12-1, denotation is gram.
2. Press b+ or b- key, display ect figure 12-2, denotation is Oz
3. Press b+ or b- key for switch maund between gram and Oz.
4. Press a+ key to save setup and exit.

13 Inch-mm conversion operation

This operation for input dimension B value and D value conversion (inch-mm).
Press inch/mm key. if in the LED display window right underside have a radix point mean currently long measure is Inch, if not,
long measure is mm.

14 Protect hood function and protect setting

This function can be setting closing protect hood motor start or lay down protect hood properly, then press START key to start
motor.
Press STOP key and C key, ect figure 14-1, right display currently state, when display ON, denotation function on, when display
OFF, denotation function off.
Press b+ or b- key for switch protect hood function between ON and OFF.
Fig. 11-4
Fig. 12-1
Fig. 12-2
Fig. 14-1
50
M1.2.BB200.NLFREN 13112018
EN