Installation; Opening And Checking; Protection Hood; Screw Stud Of Drive Axis - MW TOOLS BB200 Mode D'emploi

4 Installation

4.1 Opening and checking

Open the package and check whether there are damaged parts. If there are some problems, please do not use the equipment
and contact with the supplier. Standard accessories with equipment are shown as follow:
•

1 screw stud of drive axis

• 1 balancing pliers
• 1 Allen wrench
• 1 measure caliper
• 1 locking nut
• 4 cones
• 1 100 g counterweight
•

1 protection hood

4.2 Installation
The balancer must be installed on the solid cement or similar ground, unsolidified ground can bring measuring errors.
There should be 50 cm around the balancer in order to operate conveniently.
Nail anchor bolts on the base's mounting hole of balancer to fix the balancer.
4.3 Protection hood
Plug the pipe of protection hood into the hood shift (behind the cabinet), then fix with M10×65 screws.
4.4 Screw stud of drive axis
Install screw stud of drive axis on the main axis with M10×150 socket bolt, then screw down the bolt (see figure 4-1).
Notice: a wheel can be installed on the main axis before screwing down, then hold the wheel by
hands in order to prevent the main axis revolving together with the bolt.
Fig. 3-1
40
M1.2.BB200.NLFREN 13112018
EN