Recalculation; Imbalance Optimise; Already Display Balance Value - MW TOOLS BB200 Mode D'emploi

M1.2.BB200.NLFREN 13112018
EN
10.6.1 Split manual stick operation
2. Stick inside operation 10.3, step 3.
3. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(4)) all on, stick counterweight on 12
o'clock position outside of rim, ect figure 10-18 right side.
4. Slowly spin wheel again, when outside counterweight position indicator light (figure 5-1(4)) all on, find second position,
stick counterweight on 12 o'clock position outside of rim, ect figure 10-9 right side.
10.6.2 Split automatic stick operation
2. When stick inside, operation same as chapter 10.5.2, steps 3 and 4.
3. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(4)) all on, find first position, draught
scale, when outside counterweight position indicator light (figure 10-11) all on, turn scale, stick counterweight on rim (see
figure 10-12).
4. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(4)) all on, find second position, draught
scale, when outside counterweight position indicator light (figure 10-11) all on, turn scale, stick counterweight on rim (see
figure 10-12)
WARNING! When use scale to stick counterweight automatically, make sure LED must
display - - -, if not, do not move scale, press STOP and ALU key, then middle LED display - - -,
now you can move scale for automatically sticking counterweight.

10.7 Recalculation

Before wheel balance testing, sometimes may forget input current date of rim, you can after wheel balance testing input date
of rim reintroduce, at this time do not need press START key, just press recalculation key (C) system will follow new date of rim
calculation imbalance measure. Even interface currently display imbalance value, press C key, can be check currently input date
of rim.

11 Imbalance optimise

If wheel imbalance value over 30 gram, system will be display "OPT", clue on process imbalance optimise. Imbalance optimise
have two operation method:

11.1 Already display balance value

If already finish balance testing, when you need process imbalance optimize, press OPT key, display ect figure 11-1.
Use chalk mark a reference point on the flange plane and rim and tyre, use tyre changer exchange rim and tyre 180. Reinstall
wheel on the balancer and make sure mark of reference point between the flange plane and rim must be on the same position.
Press START key, display ect figure 11-2.
Left LED display percent of optimise, if before optimise static value is 40 gram, optimized is 85%, so after optimise static value
only 6 gram remain (= 15% × 40 gram).
Slowly spin wheel by hand, when both side two of position indicator light flashing(figure 11-3). Use mark pen make a mark on
the tyre.
Fig. 11-1
Fig. 11-2
Fig. 11-3
49