Calibration Of Measure Scale; Calibration Of Rim Distance Scale; Calibration Of Diameter Scale - MW TOOLS BB200 Mode D'emploi

8 Calibration of measure scale

The measure scale was labeled before ex-factory, but the labeled value may vary because of transportation. Therefore, users
can label it themselves before using the balancer.
After the power-on, the initialization is finished. Thus, users can label the measure scale.

8.1 Calibration of rim distance scale

1. Press and hold STOP key and press FINE key, ect 8-1, press STOP key or C key to exit.
2. Move scale to 0(zero) position, press ALU key, ect 8-2, press STOP key or C key to exit.
3. Move scale to 15, press ALU key, ect 8-3, end of self-calibration, put back measure scale.

8.2 Calibration of diameter scale

1. Installation middle size tyre on principal axis, press and hold STOP key, and press OPT key, ect 8-4, press STOP key to exit.
Fig. 7-7
Fig. 7-8
Fig. 8-1
Fig. 8-2
Fig. 8-3
Fig. 8-4
44
M1.2.BB200.NLFREN 13112018
EN