Static Balance (St) Operation Process; The Operation Process Of M1 To M2 Mode; Alu-S Balance Mode Operation Process - MW TOOLS BB200 Mode D'emploi

M1.2.BB200.NLFREN 13112018
EN

10.3 Static balance (ST) operation process

1. Move measure scale to middle of rim, and measure the data of rim.
2. Press F key, switch to static balance (ST) mode.
3. Lay down protect hood and press START key, wheel spinning, after stop middle LED display wheel static imbalance weight,
when middle LED display OPT, can choice imbalance optimise.
4. Slowly spin wheel, when both side counterweight position indicator light (figure 5-1(3), (4)) all on, stick counterweight on
12 o'clock position middle of rim, ect figure 10-8.

10.4 The operation process of M1 to M2 mode

1. Follow 7.2 input date of rim.
2. Press ALU key, switch to correspond balance mode.
3. Lay down protect hood and press START key, wheel spinning, after stop two side LED display wheel both side imbalance
weight, when middle LED display OPT, can choice imbalance optimise.
4. Slowly spin wheel, when inside counterweight position indicator light (figure 5-1(3)) all on, follow different mode clip or
stick counterweight on 12 o'clock position inside of rim.
5. Slowly spin wheel, when outside counterweight position indicator light (figure 5-1(4)) all on, follow different mode clip or
stick counterweight on 12 o'clock position outside of rim.

10.5 ALU-S balance mode operation process

10.5.1 Process of manual stickup counterweight
1. Follow chapter 7.3 input date of rim.
2. Lay down protect hood and press START key, wheel spinning, after stop two side LED display wheel both side imbalance
weight, when middle LED display OPT, can choice imbalance optimise.
3. Slowly spin wheel, when inside counterweight position indicator light(figure 5-1(3)) all on, if is follow figure 7-6 input date
of rim, clip counterweight, if Notec figure 10-9 of left side show, stick counterweight on 12 o'clock position on inside of
rim.
4. Slowly spin wheel, when outside counterweight position indicator light(fight 5-1(4)) all on, stick correspond counterweight
on 12 o'clock position on outside of rim, ect figure 10-9 right side.
Fig. 10-6
Fig. 10-8
Fig. 10-9
Fig. 10-7
47