Resetting The Rt9S - Gorgy Timing RADIO TIMING 9s Mode D'emploi

If the RT9s does not respond to your commands, or if the screen hangs, you can reset it.
RESEt (restarting)
►
Click "RESEt" located at the back of the RT9s, near the RJ-45 network connector. All
the RT9s settings will be stored when you do so. Only the time information will be lost.
A fresh synchronization will therefore be necessary for the RT9s to show the right time
following a RESET.
► factory reset (resetting of factory settings):
This process will reset the RT9s to its factory settings. All the time input/out settings will
be lost (time zone, DST policy, specific settings, etc.)
noTe
This however stores the relay output programming calendars. These cannot
be deleted by such a reset.
on the front interfaces, press the left + right + oK + escape keys.
Via Web interface (see section 5.10 reBootINg).
at the back of the rt9s, press and hold down the FD (Factory Default)
button, and press the reset button once, while holding down the FD button until
MDE-RT9s-3079V1.0
OR
OR
the screen switches off a second time.
(pressing reset will lead to a 1
8.

RESEttInG tHE Rt9S

restart).
st
125