Temperature Option; Configuration Via The Clock (Buttons) - Gorgy Timing LEDI Mode D'emploi

3.2.8. Temperature option

► Connect the temperature sensor on the both terminal marked : Probe T°C of the
terminal (no polarity).
► Temperature probe is provided with a 4 meters cable, this cable might be extended
(25 meters length maxi.)
☛
In case of an indoor temperature display, the sensor must be placed
between 1.5 to 2 meters from the ground and as far as possible from any
☛
In case of an outdoor temperature display the sensor must be placed
under a ventilated shelter, to avoid the influence of solar radiation.
☛
In case of a pool temperature display, the sensor must be placed below
☛
In wireless version, the radio transmitter must be placed out of
the water. 1000m maximum distance of transmission (and depends of
► All settings are made using the 3 buttons '+', '-' and
'PROG' at the back of the product.
► You can scroll quickly by holding down the push-
buttons.
► To exit a menu, just hold down the 'PROG', button
► or leave the buttons inactive for more than 70 se-
conds.
► You can adjust the display brightness, without going
to the menu, by pressing the buttons '+' and '-'.
You cannot make advanced settings from the timer.
MDE-LEDI-1099V3.4
heat source.
☛
Beware greenhouse effects
the surface of water.
environnement, see ANNEXE 1)
4. CONFIGURATION VIA THE CLOCK (BUTTONS)
OFF
ON
+
-
PROG
77