Recording - Arcam RMJ C30 Mode D'emploi

RECORDING

With the C30 it is possible to listen to and record from one source, or
to listen to one source while recording another.
Both sets of tape sockets are identical in sensitivity and suitable for use
with almost any type of recorder (cassette, CDR, MD, VCR, reel-to-
reel, etc.). The record signal is sent to both the
sockets.
3
RECORD
To record the currently selected source, press
shows 'RECORD SOURCE'. After a few seconds the display reverts to
showing the volume level and you are ready to record.
To listen to one source while recording another, press
until the display shows 'RECORD' followed by the name of an input (e.g.
'AUX','CD','TUNER', etc.). Now press the source selector button on the
front panel for the source you wish to record.Your selection is shown
on the display for a few seconds, after which it reverts to showing the
volume level and you are ready to record.
The button can also be used as a second zone selector, sending
RECORD
a source signal at line level to a second amplifier operating in another
room. If you need help with this, contact your Arcam dealer or Arcam
customer support.
TAPE-TO-TAPE COPYING (DUBBING)
You can perform tape dubbing from
to .
VCR
For example, to copy from a cassette recorder connected to the
socket to a cassette recorder connected to the
TAPE2
button as explained above and select 'RECORD VCR'.
use the
RECORD
This routes the VCR signal to the
Set the cassette recorder connected to the
mode and the other to playback mode to start dubbing.
8
TAPE
To play back the recording from a cassette deck attached to the
input, press . 'TAPE' is shown on the display. Selecting this input
TAPE
overrides the other source selectors.
It is also possible to monitor a recording while it is being made, provided
your cassette deck is a 3-head type.To do this, press
button on/off allows an A/B comparison between the source signal and
the recorded signal.
and output
TAPE VCR
until the display
RECORD
again
RECORD
to , but not from
VCR TAPE TAPE
VCR/
socket, first
TAPE
output.
TAPE
socket into its record
TAPE
TAPE
. Pressing this
TAPE
7