Lenz Digital Plus LH101 Mode D'emploi page 14

14
The current setting of the model watch is
displayed (the picture on the left shows the
status in the factory setting or after a reset of
the control unit)
Press the Rotary encoder to select the day of
the week setting. The cursor blinks behind
the day display.
Use the rotary knob to select the desired
weekday, ...
... confirm the selection by pressing the rotary
knob.
Now use the rotary knob to select the setting
of the hours and confirm the selection by
pressing the rotary knob.
Set the desired hour by turning ...
... and press the rotary knob.
Select the setting of the minutes ...
... and press the rotary knob.