Safety - GBC FOTON 30 Mode D'emploi

SAFETY

Safety
YOUR SAFETY, AS WELL AS THE SAFETY OF OTHERS
IS IMPORTANT TO GBC. IN THIS INSTRUCTION
MANUAL AND ON THE PRODUCT ARE IMPORTANT
SAFETY MESSAGES. BEFORE YOU INSTALL OR
USE THE MACHINE, READ AND FOLLOW ALL THE
SAFETY NOTICES CAREFULLY IN THIS CHAPTER.
Observe all the safety information provided. Observe all
safety warnings. Never remove safety warnings or other
information from the equipment.
Read all of the instructions and save these instructions for
further use.
The safety alert symbol precedes each safety
notice in this manual. The symbol indicates a
potential personal safety hazard to you or
others, as well as cause product damage or
property damage.
Observe all the safety information provided.
Observe all safety warnings. Never remove
safety warnings or other information from
the equipment.
THE FOLLOWING WARNINGS ARE FOUND ON THE
FOTON 30 LAMINATOR
Do not open. No user serviceable parts insides. Refer
servicing to qualified service personal.
CAUTION Hot Surface: Laminator rollers can
be in excess of 260° F/ 126.7° C. Please use
caution and do not touch the rollers.
WARNING: Do not attempt to service or repair
the laminator.
WARNING: Do not connect the laminator to
an electrical supply or attempt to operate
the laminator until you have completely
read these instructions. Maintain these
instructions in a convenient location for
future reference.
WARNING: This device is not intended for use
in the direct field of view at visual display
workplaces. To avoid incoming reflections
at visual display workplaces this device must
not be placed in the direct field of view.
13
General Safeguards
• Use this laminator only for its intended purposes
as according to the specifications outlined in the
operating instructions.
• Keep hands, long hair, loose clothing and articles
such as necklaces or ties away from the front of the
feed rollers to avoid entanglement and entrapment.
• When opening the top door of the laminator, avoid
contact with the internal rollers when laminator is
powered on or shortly after the laminator has been
turned off. The rollers can reach temperatures in
excess of 260º F / 126.7° C.
• Keep hands and fingers away from the path of the
sharp film cutter blade located at the film exit.
• Do not place the laminator on an unstable cart, stand
or table. An unstable surface may cause the laminator
to fall resulting in serious bodily injury. Avoid quick
stops, excessive force and uneven floor surfaces
when moving the laminator on a cart or stand.
• Do not defeat or remove electrical and mechanical
safety equipment such as interlocks, shields and
guards.
• Do not insert objects unsuitable for lamination.
• Do not expose laminator to liquids.
CAUTION: The receptacle must be located
near the equipment and easily accessible. Do
not use an extension cord.