Installation - GBC FOTON 30 Mode D'emploi

INSTALLATION

Service
WARNING: Do not attempt to service or repair
the laminator. Failure to observe this warning
could result in severe personal injury or death.
Disconnect the plug from the socket and contact Customer
Service when one or more of the following has occurred.
• The power supply cord or attachment plug is
damaged.
• Liquid has been spilled into the laminator.
• The laminator is malfunctioning after being
mishandled.
• The laminator does not operate as described in these
instructions.
Installation
• Shipping damage should be brought to the immediate
attention of the delivering carrier.
• Place the laminator on a stable flat surface capable of
supporting 23kg.
• The surface should be at least 0.75m high to assure
comfortable positioning during operation. All four
rubber feet should be on the supporting surface.
• Connect power cord to an appropriate power source.
Avoid connecting other equipment to the same branch
circuit to which the laminator is connected as this may
cause nuisance tripping of the circuit breaker or blown
fuses.
• The laminator should be positioned to allow exiting
film to drop freely to a flat surface. Accumulation of
laminated documents as they exit the laminator may
cause a jam.
• Avoid placing laminator near sources of heat or cold.
Avoid locating the laminator in the direct path of
forced, heated or cooled air.
Caring for your Foton 30
The only maintenance required by the operator is to
periodically clean the rollers. Keeping the rollers clean
ensures that your finished items will not be damaged by
dirt and adhesive build-ups.
CAUTION: the following procedure is
performed while the laminator is hot. Use
extreme caution.
WARNING: Do not apply cleaning fluids or
solvents to the rollers.
WARNING: Do not attempt to laminate
adhesives marked 'Flammable'.
WARNING: Do not expose laminator to liquids.
1. Power the machine on, wait for it to completely warm
up.
2. Open the laminator door using the silver latch.
3. Clean the top rollers with a clean, damp lint-free cloth.
If there are any adhesive build-ups, you may use
isopropyl alcohol instead of water.
4. Lift leading film edge up to the handle of the cartridge.
5. Clean the bottom rollers with a clean, damp lint-free
cloth. If there are any adhesive build-ups, you may use
isopropyl alcohol instead of water.
6. Place the leading film edge into proper position and
close the door.
7. Press and hold the RUN/STOP button for 5-7 seconds
to manually advance the rollers.
8. Open the laminator door using the silver latch.
9. Repeat steps 3 – 6.
Note: Do not use metal scouring pads to clean the heat
rollers!
WARNING: Do not laminate glitter and/or
metallic items. Damage to the rollers may
result.
The side covers, and feed table can be cleaned with a lint-
free cloth and a mild detergent.

GB
6