Controls; Specification - GBC FOTON 30 Mode D'emploi

CONTROLS

Service
To register and activate the warranty go to
ww.gbceurope.com
For details of your local service representative go to
www.gbceurope.com
Products marked with this symbol meet all
applicable Community regulations for the
European Economic Area.
Only use the laminator in indoor areas.
5
Power: turns on unit and
begins warming process,
press again to turn off.
Run/Stop: Starts and
stops lamination
Mode: Press to cycle
through operation modes.
Status indicator: used to
indicate Warming, Ready,
Running, and Error states.
Manual Feed
Ready indicator:
used to indicate when to
insert document in manual
feed modes
Activates Cutter: press
while in Manual Feed
/ Manual Cut Mode to
separate documents.
Important! Verify
completed document
before use
Film Status:
Low indicates approx. 30
documents remaining.
Empty indicates cartridge
must be replaced to
continue
Error States:
Door indicates a door
is ajar.
Jam indicates a document
jam.
Cutter indicates a cutter
error
SPECIFICATIONS
Model
Operating Speed
Operating Modes
Warm-Up Time
Maximum Feed
Capacity
Maximum Film Width
Maximum Document
Thickness
Document Lengths
Supported
Document Widths
Supported
Auto Feeder Media
Weight
Manual Feeder Media
Weight
Dimensions
• Width
• Height
• Depth
• Weight
Auto Shut-Off
Electrical
Requirements
Fuse
Operating Environment
FOTON 30
75 microns: 700mm/min
100 microns: 670mm/min
125 microns: 650mm/min
Auto Feed / Auto Cut
Manual Feed / Auto Cut
Manual Feed / Manual Cut
75 microns: 3 minutes
100 microns: 3.5 minutes
125 microns: 4 minutes
30 sheets (80gsm paper)
306mm
250gsm (Manually Fed)
Minimum: 152mm
Maximum: 432mm
Minimum: 127mm
Maximum: 297mm
High Reliability:
64-120gsm
Variable Reliability:
121-220gsm
64-250gsm
Machine
57.7cm
24.5cm
47.8cm
9.5kgs
After 15 minutes of
inactivity
220-240V, 50/60Hz
Yes (internal &
non-replaceable)
5-35C
Maximum Altitude of
2,000m