Technical Specifications; Safety Instructions - GBC QuickStart H320 Manuel D'utilisation

Technical specifications

Electrical
Machine Dimensions
Machine Weight
Maximum Pouch Width
Maximum Pouch Thickness
Maximum Thru-put Thickness
Warm-Up Time (hot lamination)
Ready Time (cold lamination)
Speed

Safety instructions

YOUR SAFETY AS WELL AS THE SAFETY OF OTHERS IS IMPORTANT
TO ACCO BRANDS. IN THIS INSTRUCTION MANUAL AND ON THE
®
PRODUCT ARE IMPORTANT SAFETY MESSAGES. READ THESE
MESSAGES CAREFULLY.
m
The SafeTY aLerT SYMBoL precedeS each SafeTY
MeSSage In ThIS InSTrucTIon ManuaL.
ThIS SYMBoL IndIcaTeS a poTenTIaL perSonaL
SafeTY haZard ThaT couLd hurT You or oTherS,
aS weLL aS cauSe producT daMage or properTY
daMage.
ThIS warnIng IS found on The producT.
c
m
Electrical shock hazard.
Do not open. No user
servicable parts inside.
Refer servicing to qualified
service personnel.
This safety message means that you could be seriously hurt or killed if
you open the product and expose yourself to hazardous voltage.
Service
Do not attempt to service or repair the pouch laminator yourself. Unplug
the unit and contact an authorized GBC
required repairs.
4
GBC QuickStart H320
230-240V/50hZ/6Amps/1200W
495 x 140 x 117.5mm
3.1kg
317mm
2x125Mic (250 Total)
1.0mm
Approximately 1 minute
Instant
483mm per min
WARNING
® service representative for any
GBC QuickStart H420
230-240V/50hZ/6Amps/1200W
495 x 140 x 117.5mm
3.9kg
317mm
2x175Mic (350 Total)
1.0mm
Approximately 1 minute
Instant
610mm per min
m
Important safeguards
m
warnIng: for Your proTecTIon do noT connecT
The pouch LaMInaTor To eLecTrIcaL power unTIL
You read TheSe InSTrucTIonS coMpLeTeLY. Keep
TheSe InSTrucTIonS In a conVenIenT LocaTIon for
fuTure reference. To guard agaInST InJurY, The
foLLowIng BaSIc SafeTY precauTIonS MuST Be
oBSerVed In The SeT-up and uSe of ThIS producT.
Electrical safeguards
• The unit must be connected to a supply voltage corresponding to the
electrical rating shown on the unit.
• Unplug the unit before moving it, or when it is not in use for an
extended period of time.
• Do not operate with a damaged supply cord or plug. Do not alter the
attachment plug. The plug is configured for the appropriate electrical
supply.
• Do not overload electrical outlets beyond their capacity. Fire or
electrical shock could result.
• The unit is intended for indoor use only.
• Do not spill liquid of any kind on this product.
• Close supervision is required when this product is used near children.
General safeguards
• Use the unit only for its intended purpose of laminating documents.
• Do not place anything in the throat opening of the laminator other than
pouches/documents.
• Place unit on a secure, stable work area to prevent the unit from
falling and possibly causing personal injury and damage to the unit.
• Follow all warnings and instructions
• The socket outlet shall be installed near the equipment and shall be
easily accessible.
• Do not attempt single side lamination, this will destroy the laminator.
• Do not block the vent slots, this will cause the laminator to overheat.
m