Pride Mobility Products Go-Go iCruise S25 Manuel De L'utilisateur page 27

I I I . B A T T E R I E S A N D C H A R G I N G
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
What about public transportation?
Your Go-Go iCruise Lithium-Ion battery has been tested and complies with United Nations Transport Regulations
standard UN38.3 and conforms to 49 CFR 175.10(a)(17).
NOTE: Airline policies and regulations may vary. Check with individual airline prior to travel.
How do I change the battery in my scooter?
MANDATORY!
must be purchased from an authorized
Dealer. The battery pack must not to be
opened.
WARNING! Contact your Dealer if you have
any questions regarding the battery in your
scooter.
WARNING! Do not replace the battery while
the scooter is occupied.
WARNING! Do not pull on electrical lead
wires directly to detach them from the
scooter. Always grasp the connector itself
when disconnecting the lead to prevent wire
damage.
To change the battery pack, see fi gure 18:
1. Ensure the battery pack power button is off .
2. Disconnect the black and red wires that go directly to the
battery.
3. Unfasten the battery strap.
4. Remove the old battery pack from the scooter.
5. Install the new battery pack onto scooter.
6. Fasten the battery strap.
7. Connect the black and red wires on the new battery pack
to the scooter.
NOTE: Contact your local waste disposal agency or authorized Dealer for information on proper battery disposal.
Go-Go iCruise
All Go-Go iCruise batteries
IDENTIFICATION KEY
1. Power Button/Main Circuit Breaker
2. Battery Strap
3. Battery Pack
4. Battery Connector
1
4
Figure 18. Battery Pack Replacement
2 3
27