Maintenance; Fuse Replacement; Preparation For Maintenance; Side View - Napoleon EFL50H Instructions D'installation Et D'opération

14

6.0 MAINTENANCE

6.1

FUSE REPLACEMENT

EN
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
DO NOT INSTALL REPLACEMENT LAMPS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE HALOGEN LAMPS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST
10 MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE LAMPS TO AVOID
DO NOT HANDLE THE LAMP WITH BARE FINGERS, OILS FROM YOUR SKIN WILL DAMAGE THE
LAMPS WHEY THEY HEAT UP. USE GLOVES OR A CLEAN DRY CLOTH WHEN HANDLING LAMPS.
To replace the fuse remove the glass door see "GLASS DOOR REMOVAL" section.
A. Remove the glass media from the appliance, glass embers may have sharp edges,
wear safety glasses and gloves when handling.
B. Remove 4 screws on each side of the appliance that secure the fi rebox front and
mirror glass holder and remove from the appliance, the circuit board will become
visible, as shown below
C. Remove the mirror glass prior to accessing the circuit board.
D. Remove the fuse cover to gain access to the fuse and replace the existing fuse with
the new fuse.
GLASS
FRONT
W415-1223 / A / 01.11.14

PREPARATION FOR MAINTENANCE

CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.

SIDE VIEW

WARNING
!
ACCIDENTAL BURNS.
FUSE COVER