Replacing Paper - GYS BT 2010 Mode D'emploi

Translation of the original manual

REPLACING PAPER

A. Open the transparent
cover.
DATA RECORDING ON PC
1. Insert the CD into the drive.
2. Follow the installation instructions and install the «Decode_BT2010WWWVxx» icon. The table below is displayed.
3. Enter the test code into the table manually or by a scanned bar code.
4. The test result appears in a table.
5. The data can be recorded on PC.
MAINTENANCE
Examples
Display switched off
Printing fault
Insufficient internal battery
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported
BT 2010
B. Place a new roll of paper in the
compartment.
Reference paper : 056237 or
056633
Check that the device is connected to the battery. The battery voltage is not high
enough to perform the test (<1.0 V). Fully charge the battery and try again.
Paper jam: the paper is not inserted correctly. Out of print paper: Insert paper.
Replace the batteries in the tester.
C. Place a small length of paper
from the compartment and press
the transparent cover to close.
Solutions
EN
11