Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CaUtIon: Ensure the Aeroccino is cold before removing it from the base. Or, if removing with care, rinse with cold water
immediately to cool down the Aeroccino and avoid burning risks.
CaUtIon: Do not immerse neither the Aeroccino nor the base in the water.
CaUtIon: In case the base needs to be cleaned, unplug it first and use only a damp cloth. Make sure the
connector is dry before operation. Do not immerse the base in water nor put it in the dishwasher.
CaUtIon: If the bottom part of the Aeroccino is wet, dry it before putting it back in contact with the base
connector.
of scratches and harm to the Aeroccino coating.
trouBLeSHootIng
Aeroccino does not start
Quality of milk froth not up to standard
Red Button blinking
Milk Overflows
SpeCIfICatIonS
CaUtIon: only use non-abrasive cleaning materials. Do not use abrasives, sharp objects, brushes: risk
➔ Be sure to position the jug correctly on a clean base. Be sure to attach the whisk to the jug correctly
➔ Be sure to use whole or semi-skimmed milk at refrigerated temperature (39-43 F)
➔ Be sure to use the appropriate whisk and the jug is clean
➔ a) The appliance is too hot. Rinse it under cool water b) Whisk is missing c) Not enough milk. Fill milk frother up to one of the
two «max» level
➔ Be sure to use the appropriate whisk and check the corresponding indicator level
USA/CA:
3594
BR/MX:
120V, 60Hz, 450W
AR:
220V, 50Hz, 410W
127V, 60Hz, 505W
BR/CL:
220V-240V, 50-60Hz, 430-500W
EN
CO:
120 V, 60 Hz, 450W
AUS:
220-240V, 50-60Hz, 450W
11
Publicité
Table des Matières
